To replace the cartridge in your kitchen faucet, you first need to disassemble the faucet body. To do this, remove the plastic cap at the top of the handle and expose the screws. To remove the cartridge, you may use pliers to push it down. Next, you should remove the retainer clip. You can use a flat-blade screwdriver or a pair of needle-nose pliers to unscrew the retaining clip. Once you have removed the retainer clip, you can then install the new cartridge.
You should follow the procedure closely and record every step. Once you have removed the parts, you can clean them using a fine nylon abrasive pad. If necessary, you can also use vinegar to remove mineral deposits. Then, put the parts back together and reassemble the faucet. This should be done within an hour.
The nuts holding the faucet in place are a little tricky to remove. Sometimes they become stuck or rusted. You can try cleaning the nuts with a wire brush or penetration oil, which should dissolve the corrosion. After that, you can try cutting the nuts with a hacksaw or reciprocating saw. If this method does not work, you can call a plumber to perform the task for you.
You can also use a hair dryer to loosen the valve. If this is not possible, use locking pliers to coax the valve into the Off position. Be careful to avoid excessive twisting pressure. This can damage the valve and the supply line. Moreover, it is crucial to keep the water supply turned off during the replacement.
In addition to replacing the valve, you can also replace the O-rings. These o-rings are attached to the spout and are responsible for regulating the flow of water. In addition, you can also replace the cartridge in Moen faucets. This way, you can restore the performance of the faucet and make daily tasks easier.
A faucet repair kit can be purchased at a hardware store or a plumbing supply store. Sometimes you may need to order parts if it's a disc-type faucet. Most stores do not carry all faucet parts in stock. Before you visit the store, make sure to know the brand name of your faucet and bring along the original cartridge. It will help to match the part with the photo on the parts catalogue.
Use a plywood sheet
If you cannot remove the faucet from the cabinet, you can use a plywood sheet inserted into the cabinet. It should be narrow enough to fit through the cabinet door. It should also be long enough to support the back of the faucet. You can then support the sheet of plywood with six to eight quart-size paint cans. This will create a flat work surface on which to replace the faucet.
There are many types of traditional kitchen tap. One of the most common is a deck-mounted faucet. This faucet requires holes in the sink and countertop. This type of faucet will free up countertop space and make cleanup easier. However, it is not recommended for exterior walls of homes in colder climates.
