hidden gps tracker for car is not the navigation we usually use, but a hidden gps tracker for car that locates your car so that you can know where your car is anytime, anywhere. Hidden gps tracker for car has a built-in GPS module The terminal with the mobile communication module is used to transmit the positioning data obtained by the GPS module to a server on the Internet through the mobile communication module (gsm/gprs network), so that the terminal position can be inquired on the computer. Although hidden gps tracker for car is easy to install, what should we pay attention to during the installation process?
1. Connect the GPS antenna and the GSM antenna first. Note that these two antennas cannot be connected incorrectly, otherwise they will not work properly. The square type is the GPS antenna, and the T type is the GSM antenna. Put the mobile phone card on the card slot, with the metal side facing out, and insert it into the device. The device has a backup battery and can work for several hours without external power supply. After the device is turned on, the red light flashes and the blue light is always on after the device is positioned. The red light and the blue light are in the same hole.
2. After the device is turned on and positioned, connect the power cord, the red one is connected to the positive pole, and the black one is connected to the negative pole.
3. Connect the emergency alarm button, the blue wire is connected to the red wire of the alarm wire, and the black wire is connected to the black wire of the alarm wire. The alarm button is not required to be installed, and the user can decide whether to install it according to his own needs.
4. Install oil-cut and power-off, the equipment can support both oil-cut and power-off. Generally, it is enough to connect one of the oil-cut or power-off. When the oil is cut off or the power is cut off, a relay is required. The relay has 4 wires (12V) or 5 wires (24V), and one of the 5 wires does not need to be connected. For the specific wiring, please refer to the wiring diagram. It is not necessary to cut off oil or power off, and users can decide whether to install it according to their own needs.
5. If there is an anti-theft device installed on the car, connect the pink detection alarm wire to the positive pole of the alarm horn. When the horn alarms, the device will also alarm and notify the user at the same time.
6. The custom line can detect high and low voltage and send the status to the server. Users can define the meaning of this line according to their needs.
hidden gps tracker for car https://www.eelinktracker.com/Magnetic-GPS-Tracker/
